Prometheus Design Werx | Ti-SAK Scales - Raven Black

Materials:

• 6AL-4V Titanium
• 316 Stainless Steel Machine Screws

Approx. Dimensions:

• Height: 91mm
• Width: 18.03mm Tapers to 20.06mm
• Thickness: 3.9mm

Features:

• Fully Shaped and Contoured Titanium
• SPD Edition Laser Etched "Raven Black Finish" Pattern
• Titanium Biller Pocket Clip
• Standard 3 Hole Pattern Allows for Other Aftermarket Pocket Clips
• Slot for Factory Pen Accessory
• Slot for Factory Tweezers
• Slot for Factory Toothpick
• Slot for Factory Stick Pin
• SPD Kraken Trident Laser Mark

Approx. Weight:

• 1.46oz

SAK IS NOT INCLUDED

Modification of your 91mm type SAK with these titanium scales are done so at your own risk. This is a home DIY modification. Install with caution, know what you are doing, know how to operate a vice or clamps safely. Prometheus Design Werx, INC is not to be held responsible for any damage to your SAK and the titanium scales during installation. Please click here for step by step installation instructions.  

Please note that these are intended as a permanent replacement for the factory scales. These are precisely machined to match the brass ferrules of a 91mm SAK and will easily press fit into place with a vice or clamps and a piece of leather to pad the jaws.*Warning, when using other after market 3 hole pattern pocket clips, make sure you use the correct length machine screws so they are not so long where they will press out the flush fit titanium scale.